Wunder-audio CM12 Manuel d'utilisateur télécharger pdf (Page 4)

directly next to the large AC transformer.

To set the switch to 115V, toggle the switch towards the

transformer. To set the switch to 230V, toggle the switch away from

the transformer.

Warning: Connecting the CM12 to the wrong AC voltage may

destroy the unit and cause ﬁre and/or electric shock.

Replacing Fuses

The fuse protecting the primary circuit is located outside the PSU.

Unscrew the black fuse cover to open the fuse compartment.

Replace the fuse with a new fuse of the same type (T 500 mA for

115V; 250 mA for 230V) and close the fuse compartment lid.

AC Power Connector

If you are using the microphone in a different country, you may

need to connect the unit to a power outlet that does not match the

power connector on the supplied power cable. Purchase a matching

power cable locally that complies with IEC and local safety

standards and has a power connector with a chassis ground pin.

While in the same area, use this “local“ power cable only.

Shutdown and Storage

Before switching off the microphone or disconnecting cables, reduce

the volume of the connected equipment. Only then should the PSU

be switched off.

Disconnect the cables. When disconnecting a cable, always pull only

on the connector housing and not the cable itself.

When the microphone is not in use it should not be allowed to

remain on the stand gathering dust.

A microphone that is unused for a prolonged period should be

1 2 3 4 5 6

Pas de commentaire

Wunder-audio CM12 Manuel d'utilisateur Page 4