Wunder-audio CM12 Manuel d'utilisateur télécharger pdf (Page 2)

longer be used.

1. Disconnect microphone from PSU.

2. Turn the three grub screws at the lower end of the microphone

into the body in a clockwise direction until the outer housing can

be pulled off in a downwards direction.

3. The vacuum tube may now be removed by depressing the lower

(rubber) shockmount to free the tube with a forward motion.

Taking the tube socket in one hand and the tube itself in the

other hand will enable you to separate the vacuum tube from

the socket.

4. Insertion of a new tube should be done in reverse order

of the description above.

Operation

The CM12 is equipped with an 8-pin Swivel-Mount connector that

plugs into the base of the microphone and screws tight. Always

make sure that the PSU is switched off when plugging the

microphone connector into the microphone and PSU.

How to Change the Polar Pattern

Locate the white pattern switch on the PSU. Use this switch to

change the directional characteristics: omni-, cardioid-, ﬁgure-eight,

and eight intermediate positions. The center position with the

Wunder Audio logo is the cardioid setting.

As you turn from position to position it will take a few seconds for the

polarization voltage to settle and achieve the desired polar pattern.

How to Mount the Microphone

A special swivel mount/stand adapter is provided and should always

be used to mount the microphone on ﬂoor stands or booms. The

CM12 can now be placed with the microphone on stands or booms

1 2 3 4 5 6

Pas de commentaire

Wunder-audio CM12 Manuel d'utilisateur Page 2